Gate Assembly Instructions
Remove the components from the box. There will be 8 gate legs, 8 rectangular gate feet, and 4 numbered gate banners.
Place the bottom of a gate leg into the slot in a gate foot. Twist the gate leg clockwise to lock in place.
For each leg, pull the wide head of the pin near the top of the Gate so that it is sticking out, but not removed from the Gate. The small, forked end should prevent the pin from being fully removed.
Hold your Gate banner by the open long edge. Slide the Gate banner into the open slot of the gate leg.
While holding the Gate, push the pin through the open hole, which should be lined up with the pin. If the Gate is in the proper position, it should not take much force.
Repeat these steps to attach a leg to the other side of the Gate banner, then repeat for the remaining Gates.