Needing to repackage Rift Rally but now you have the challenging task of putting everything back in the box. Don’t worry, this guide is here to help you do just that!
- Start by detaching the base and legs from the gates. For each leg, pull the wide head of the pin near the top of the Gate so that it is sticking out, but not removed from the Gate. The small, forked end should prevent the pin from being fully removed. Slide the cardboard gates out from the leg. Twist the leg counter-clockwise and then pull up from the base to separate them.
- Next, you’ll want to find the 3 boxes that hold the gates. 3 legs go in each of the large boxes and two legs go in the smallest box. Place the gates inside of each box.
- Place the large leg boxes inside of the gate set box and push them towards the front.
- Place the small leg box on top of the large leg box and push it towards the front right hand corner. Place the car next to the small leg box. The car tires will fit perfectly in the open slots on the bottom box.
- Pick up the four gate toppers. Place the four gate toppers into the small gap at the back of the gate set box.
- Stack the base of the gate legs on top of each other and turn them on their side. Place the stacked bases on the left side of the box.
- Pick up the cardboard cover for the gate bases. Place the cardboard cover over the gate bases with the indents toward the top of the stack.
- Close the box and celebrate!